2007 Suzuki Grand Vitara Owner's Manual - Page 26
2007 Suzuki Grand Vitara Manual
Page 26 highlights
BEFORE DRIVING CAUTION The transmitter/remote controller is a sensitive electronic instrument. To avoid damaging it, do not expose it to dust or moisture or tamper with internal parts. Programming/removing a transmitter code yourself Your new vehicle was originally equipped with two transmitters. If you have lost one of the transmitters, you should change the transmitter code in your vehicle's memory as soon as possible for security. If you purchase additional transmitters, the new transmitters need to be programmed into your vehicle's memory. You can perform this yourself by using the following procedure: NOTE: • You can program up to three transmitter codes into your vehicle's memory. The three codes may be the same or different. • If you try to program a fourth code, the oldest code will be cleared automatically. • To purchase new transmitters, see your SUZUKI dealer. • Before you begin programming, have all of your transmitters available. To program a new transmitter 1) Confirm that all the doors are closed and the ignition key is out of the ignition switch. 2) Open the driver's door. 3) Insert the key, turn the ignition switch to the "ON" position, turn the ignition switch to the "LOCK" position and remove the key within 10 seconds. (2) 52D212 (1) 66J018 4) Push and release the driver's door switch (1) 3 times, insert the key, and turn the ignition switch to the "ON" position within 20 seconds. 5) Turn the ignition switch to the "LOCK" position and remove the key within 10 seconds. All doors will lock/unlock to confirm that this procedure has been properly completed. 6) Press the "UNLOCK" button (2) on the transmitter one time within 20 seconds (after step 5). All the doors will lock/ unlock to confirm that the procedure has been completed and the transmitter has been programmed. 7) If you want to program an additional transmitter, repeat the procedure from step 1) through step 6). 8) Make sure that the keyless entry system operates properly by operating each transmitter. 2-12