AIWA CDS-TD66 Operating Instructions - Page 9
General
View all AIWA CDS-TD66 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
GENERAL SOUND ADJUSTMENT SETTING THE SLEEP TIMER Volume or tone adjustment does not affect recording. The unit can be turned off automatically at a specified time. VOLUME (VOL) Press VOLUME N or M. The volume level is displayed as a number from 0 to MAX (25). 1 Keep REPEAT/SLEEP pressed until "30" flashes in the display. • The volume level is automatically set to 14 if the power is turned off when the volume level is set to 15 or more. (except when turning the power back on within 4 seconds) • Pressing DISPLAY on the remote control displays the adjusted volume level (CSD-TD66 only). 2 Within 4 seconds, press r or t to 3-MODE EQUALIZER Press * 3-MODE EQUALIZER repeatedly until the desired mode is displayed. The equalizer mode changes to R (Rock), P (Pop), specify the time until the power is turned off. Each time it is pressed, the time changes between 10 and 90 minutes in 10-minute steps. J (Jazz) or no equalization, cyclically. Rock - Emphasizes the high and low range of music. Pop - Emphasizes voice and midrange of music. Jazz - Emphasizes the low range of music. * or EQ on the remote control (CSD-TD66 only) Specified time While the sleep timer works, T-BASS system the dot keeps flashing. The T-BASS system enhances the realism of lowfrequency sound. Press T-BASS and the T-BASS indicator lights up. To check the time remaining until the power is turned off En Repeat step 1 shown above. The remaining time is QSOUND system displayed for 4 seconds. This system provides a rich, three dimensional sound area for stereo sources. You can enjoy more enhanced sound. Press QSOUND and the QSOUND indicator lights up. To cancel the sleep timer Display the remaining time and press r or t repeatedly until OFF is displayed. • At higher volumes, turning QSOUND on may cause sound distortion. In this case, make the volume down. NOTE If the unit is turned off during tape playback, x on the deck will not be released. Press Z to release x. Maintenance To clean the cabinet Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner. To clean the heads When the tape heads are dirty; - high frequency sound is not emitted - the sound is not adequately high - the sound is off-balance - the tape cannot be erased - the tape cannot be recorded on After every 10 hours of use, clean the tape heads with a head cleaning cassette. Use separately sold dry-type or wet-type cleaning cassette. Refer to the instructions of the cleaning cassette for details. To clean the lens Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge. Lens ENGLISH 9