AIWA TS-W150 Operating Instructions - Page 5

B Connection Note Do not plug in the AC power cords of both TS-W150 and the epuipment to the AC power outlets before all other connections are made. Preparations Turn off the power of the equipment and remove the speaker cords from the speaker terminals on the equipment. 1 Connect the speaker terminals on E the equipment to the INPUT 2 (FROM SPEAKERS OUT) terminals on S TS-W150 with Cthe supplied speaker cords. • Make sure the L and R and the ) and (cords are connected correctly. 2 With the speaker cords removed from the equipment (see "Preparations" above), connect R the right and L left speakers to the SPEAKERS OUT terminals on STS-W150. 3 Set the INPUT SELECT switch to "2". 4 Connect the AC power cord to an AC outlet. Note Use left/right speakers whose impedance corresponds with the value specified on the equipment. Dynamic Bass System The TS-W150 adopts a Dynamic Bass System in which port (1), and air cavity (2) compose an acoustic bandpass filter in front of air cavity (1). By virtue of this structure, the bass reproduction limit is extended and sounds higher than middle range frequencies are reduced in the Dynamic Bass System. This makes it possible for the TS-W150 to reproduce powerful En bass sound. 5