AIWA TS-W150 Operating Instructions - Page 7

Phase Depending upon the room or the characteristics of the right and left speakers, sound from the powered subwoofer may seem unnatural or unusually loud or soft. In this case, try changing the PHASE switch setting. Set to the NORMAL or REVERSE position, whichever sounds better. BASS SOUND RANGE You can adjust the sound range of the powered subwoofer to complement the sound range of the other speakers. Set the TURN OVER switch to one of the three positions. 60 Hz: Output 60 Hz and under. 100 Hz: Output 100 Hz and under. 150 Hz: Output 150 Hz and under. SPECIFICATIONS Input terminals INPUT 1 jack INPUT 2 terminals Input sensitivity/impedance INPUT 1: 400 mV/10 kilo ohms (at 50 Hz) INPUT 2: 4 V/4.5 kilo ohms (L and R) (at 50 Hz) Output terminals Power output En SPEAKERS OUT terminals 150 W (4 ohms, T.H.D. less than 1%, at 50 Hz to 200 Hz) 180 W (4 ohms, T.H.D. 10%, at 100 Hz) Frequency response 50 Hz - 200 Hz Speaker type Bass reflex type Speaker unit 25 cm (9 7/8 in.)(Magnetically shielded type) Power requirement AC 120 V, 60 Hz Power consumption 70 W Dimensions (w/h/d) 320 × 378 × 447 mm ( 12 5/8 × 15 × 17 5/8 in.) Weight 14.1 kg (31 lbs 1 oz.) Specifications and external appearance are subject to change without notice. AUTO POWER Before using this function, make sure the POWER button is set to ON. While the AUTO POWER switch is set to ON, the power is automatically turned on when receiving a signal input from either INPUT 1 or INPUT 2. The power is automatically turned off if no signal is input for a while and the indicator of the POWER button turns off. If input signal is too weak (e.g. at a quiet scene in a DVD playback), this function may not work. In such a case, set the AUTO POWER switch to OFF. 7