ASRock Fatal1ty P67 Performance Quick Installation Guide - Page 20

2.6 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! FDD connector (33-pin FLOPPY1) (see p.4 No. 30) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Black) (39-pin IDE1, see p.4 No. 8) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATAII Connectors (SATA2_2: see p.4, No. 21) (SATA2_3: see p.4, No. 20) (SATA2_4: see p.4, No. 22) (SATA2_5: see p.4, No. 23) SATA2_3 SATA2_2 SATA2_5 SATA2_4 These four Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. Serial ATA3 Connectors (SATA3_0: see p.4, No. 19) (SATA3_1: see p.4, No. 18) SATA3_1 SATA3_0 These two Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. The current SATA3 interface allows up to 6.0 Gb/s data transfer rate. If you install the HDD on the eSATA port on the rear I/O, the internal SATA3_1 will not function. Serial ATA (SATA) Either end of the SATA data Data Cable cable can be connected to the (Optional) SATA / SATAII / SATA3 hard disk or the SATAII / SATA3 connector on this motherboard. 20 Fatal1ty P67 Performance Series Motherboard English