ASRock QC5000M Quick Installation Guide - Page 17
Hese two SATA3
View all ASRock QC5000M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Serial ATA3 Connectors (SATA3_1: see p.1, No. 5) (SATA3_2: see p.1, No. 6) SATA3_1 SATA3_2 QC5000M hese two SATA3 connectors support SATA data cables for internal storage devices with up to 6.0 Gb/s data transfer rate. USB 2.0 Headers (9-pin USB4_5) (see p.1, No. 7) (9-pin USB6_7) (see p.1, No. 12) USB_PWR PP+ GND DUMMY 1 GND P+ PUSB_PWR Besides four USB 2.0 ports on the I/O panel, there are two headers on this motherboard. Each USB 2.0 header can support two ports. Front Panel Audio Header 1 (9-pin HD_AUDIO1) MIC2_L MIC2_R (see p.1, No. 14) OUT2_R J_SENS E OUT2_L his header is for GND PRESENCE# connecting audio devices MIC_RET to the front audio panel. OUT_RET 1. High Deinition Audio supports Jack Sensing, but the panel wire on the chassis must support HDA to function correctly. Please follow the instructions in our manual and chassis manual to install your system. 2. If you use an AC'97 audio panel, please install it to the front panel audio header by the steps below: A. Connect Mic_IN (MIC) to MIC2_L. B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L. C. Connect Ground (GND) to Ground (GND). D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect them for the AC'97 audio panel. E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and adjust "Recording Volume". English 15