ATI 100-505141 User Guide - Page 15
Turning on the System, Display Configurations
UPC - 727419412896
View all ATI 100-505141 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Detailed Installation 9 Display Configurations The FireMV™ 2200 graphics card provides dual display functionality. The following table lists the different ways you can connect displays to your card. Display Connector(s) Configuration Used Comments Single CRT display Single DFP display DFP display + DFP Display CRT display + DFP display CRT display + CRT display VGA connector with DVI-I-to-VGA adapter DVI-I connector CRT- cathode ray tube analog display. The DVI-I connection can support a CRT display using the DVI-I-to-VGA adapter. DFP - digital flat panel display. DVI-I connector + DVI-I connector VGA connector with DVI-I-to-VGA adapter + DVI-I connector VGA connector with DVI-I-to-VGA adapter + VGA connector with DVI-I-to-VGA adapter Turning on the System L WARNING - Turn on your monitor before you turn on your computer. Failure to do so could damage your monitor. If you have properly installed your graphics card, operating system messages will appear once the boot procedure is finished. Your monitor will be running in a basic video mode. Higher refresh rates are not available at this stage of the installation. Once you have installed the FireMV™ 2200 drivers and software, you can use the Display Properties control panel to adjust the video settings and configure multiple monitors.