Acer Aspire 4810TZ Aspire 4810T, 4810TG, 4810TZ and 4410TZG Service Guide - Page 40

Security The Security screen contains parameters that help safeguard and protect your computer from unauthorized use. InsydeH20 Setup Utility Information Main Security Boot Exit Supervisor Password Is Clear User Password Is Clear HDD Password Clear Set Supervisor Password Set User Password Set Hdd Password Power on password [Disabled] Rev. 3.5 Item Specific Help Install or Change the passeord and the length of password must be greater than one word. F1 Help Esc Exit Select Item F5/F6 Change Values F9 Setup Default Select Menu Enter Select►Sub-Menu F10 Save and Exit NOTE: Please refer to "Remove HDD/BIOS Password" section if you need to know how to remove HDD/BIOS Password. The table below describes the parameters in this screen. Settings in boldface are the default and suggested parameter settings. Parameter Supervisor Password Is User Password Is HDD Password Is Set Supervisor Password Set User Password Set HDD Password Password on Boot 32 Description Shows the setting of the Supervisor password Shows the setting of the user password. Shows the setting of the hard disk password. Press Enter to set the supervisor password. When set, this password protects the BIOS Setup Utility from unauthorized access. The user can not either enter the Setup menu nor change the value of parameters. Press Enter to set the user password. When user password is set, this password protects the BIOS Setup Utility from unauthorized access. The user can enter Setup menu only and does not have right to change the value of parameters. Enter HDD Password. Defines whether a password is required or not while the events defined in this group happened. The following sub-options are all requires the Supervisor password for changes and should be grayed out if the user password was used to enter setup. Option Clear or Set Clear or Set Clear or Set Disabled or Enabled Chapter 2