Acer Aspire 5230 Aspire 5230 Service Guide - Page 41

Parameter On chip SATA SATA Class ID SATA IDE Combined mode PATA Channel Config ACHI ROM POST delay USB Host Controller Legacy USB Support Option ROM Placement Large Disk Access Mode Installed O/S Reset Configuration Data Processor Assisted Virtualization Description Enable On chip SATA. Select the SATA Class ID. Set SATA IDE Combined mode. Set the SATA channel as Primary or Secondary channel. Select SATA option ROM POST delay. Enable or disable USB hardware. Enable support for Legacy Universal Serial Bus. Determines which peripheral devices can be booted. NOTE: Changes to this setting can cause the system to halt during boot. Set the Large Disk Access mode. Different O/S require different drive geometry representations. Select Other for UNIX, Novell NetWare, or other O/S. Set the most commonly used O/S on the system. Clear Extended System Configuration Data (ESCD) area. Enable the hardware visualization support. Submenu Items Option: Enabled or Disabled Option: IDE-ACHI Class, HyperFlash Class, IDE-HyperFlash Class, IDE Native Mode, Raid Class, ACHI Class, or IDE Legacy Mode Option: Disabled or Enabled Option: SATA as primary or SATA as secondary Option: Disabled, 7, 6, 5, 4, 3, 2, or 1 second(s) delay Option: Enabled or Disabled Option: Enabled or Disabled Option: Disabled, Temporary, or E000 Extend Option: DOS or Other Option: Other, Win2000, WinMe, Win98, or Win95 Option: No or Yes Option: Enabled or Disabled. Chapter 2 29