Acer Aspire 9300 Aspire 9300 / Aspire 7000 Service Guide - Page 92

Index of Error Messages Error Message List Error Messages Struck Key System CMOS checksum bad Default configuration used Real time clock error Previous boot incomplete - Default configuration used FRU/Action in Sequence See "Keyboard or Auxiliary Input Device Check". RTC battery Run BIOS Setup Utility to reconfigure system, then reboot system. RTC battery Run BIOS Setup Utility to reconfigure system time, then reboot system. Main board "Load Default Settings" in BIOS Setup Utility. RTC battery Main board Invalid System Configuration Data "Load Default Settings" in BIOS Setup Utility. Main board Operating system not found Power-on indicator turns off and LCD is blank. Enter Setup and see if fixed disk and drive A are properly identified. Diskette drive Hard disk drive Main board Power source (battery pack and power adapter.) See "Power System Check". Ensure every connector is connected tightly and correctly. Reconnect the DIMM. Main board. Power-on indicator turns on and LCD is blank. Power-on indicator turns on and LCD is blank. But you can see POST on an external CRT. Power-on indicator turns on and a blinking cursor shown on LCD during POST. Power source (battery pack and power adapter.) See "Power System Check". Reconnect the LCD connector Hard disk drive LCD cable LCD inverter LCD Main board Reconnect the LCD connectors. LCD cable LCD inverter LCD Main board Ensure every connector is connected tightly and correctly. Main board Chapter 4 82