Home » Acer Manuals » Desktops » Acer Power ST » Manual Viewer

Acer Power ST Aspire T300 Service Guide - Page 31

MB, 3.5-inch, Disabled, VGA/EGA, All Errors, Parameter, Description, Options, However - power settings

Get Acer Power ST PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Parameter Description Options IDE Secondary Channel Master Allows you to configure the hard disk drive connected to the master port of IDE channel 2. To enter the IDE Secondary Master setup, press [Enter]. The IDE CD-ROM is always automatically detected. IDE Device Model Number: None IDE Secondary Channel Slave Allows you to configure the hard disk drive connected to the slave port of IDE channel 2. To enter the IDE Secondary Slave setup, press [Enter]. The IDE CD-ROM is always automatically detected. IDE Device Model Number: None Drive A Allows you to configure your floppy drive A. 1.44 MB, 3.5-inch None 360 KB, 5.25-inch 1.2 MB, 5.25-inch 720 KB, 3.5-inch 2.88 MB, 3.5-inch Drive B Allows you to configure your floppy drive B. 1.44 MB, 3.5-inch None 360 KB, 5.25-inch 1.2 MB, 5.25-inch 720 KB, 3.5-inch 2.88 MB, 3.5-inch Floppy 3 Mode Support Floppy 3 is the standard Japanese floppy drive mode. Supported by the BIOS, the selected diskette drive can read 720KB, 1.2MB and 1.44MB on a 3.5" diskette. Disabled, Enabled. Video This item specifies the type of video card in use. The default setting is VGA/EGA. Since current PCs use VGA only, this function is almost useless and may be disregarded in the future. VGA/EGA CGA40 CGA80 Mono Halt On This parameter enables you to control the system stops in case of Power On Self Test errors (POST). All Errors No Errors All but Keyboard All but Diskette All by Disk/Key Base Memory Refers to the option of memory that is available to standard DOS programs. DOS systems have an address space od 1MB, but the top 384KB (called high memory) is reserved for system use. This leaves 640 KB of conventional memory. Everything above 1MB is either extended or extended memory. Extended Memory Memory above and beyond the standard 1MB of base memory that DOS supports. Extended memory is only available in PCs with an Intel 80286 or later microprocessor. Extended memory is not configured in any special manner and is therefore unavailable to most DOS programs. However, MS Windows and OS/2 can use extended memory. Total Memory Total based and extended memory, and I/O ROM 384KB available to the system. Chapter 2 25

Section	Page
Aspire T300_AcerPower ST	1
Revision History	2
Copyright	3
Disclaimer	3
Conventions	4
Preface	5
Ch.1 System Specifications	7
Overview	7
Features & Specifications	8
Front Panel	10
Rear Panel	12
Aspire T300/Power ST Main Board Layout	13
Hardware Specifications and Configurations	15
Power Management Function (ACPI support function)	23
Ch.2 System Utilities	25
Entering Setup	26
Product Information	28
Standard CMOS Features	30
IDE Primary/Secondary Channel Master/Slave Setup	32
Advanced BIOS Features	33
Advanced Chipset Features	35
Integrated Peripherals	37
Power Management Setup	39
PnP/PCI Configuration	41
PC Health Status	42
Frequency Control	43
Load Default Settings	44
Set Supervisor/User Password	45
Save & Exit Setup/Exit Without Saving	47
General Information	50
Before You Begin	50
Disassembly Procedure Flowchart	51
Standard Disassembly Procedure	52
Removing the CD-ROM/CD-RW Drive	52
Removing the Front Panel	53
Removing the HDD/Floppy Cage	53
Ch.4 Troubleshooting	55
Power-On Self-Test (POST)	56
POST Check Points	57
POST Error Messages List	63
Error Symptoms List	65
Ch.5 Jumper and Connector Information	69
Aspire T300/APST Jumpers and Connectors	69
Connector Description	70
Jumper Settings	70

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

You can visit the Acer Power ST on the Acer site to download this or other manuals by visiting this link.

We apologize for any inconveniece.