Acer Power ST Aspire T300 Service Guide - Page 40

Parameter Video Off Option Video Off Method Modem Use IRQ HDD Power Down Soft-off by PWR-BTTN Aftrer PC Power Lost Power On by Ring Wake-Up by PCI Card Resume by Alarm Description Options This item is to control the mode in which the monitor will shut down. Always On: Always keep the monitor on. Suspend --> Off: During suspend mode, the monitorwill shut down. Susp, Stby --> During suspend or standby mode, the monitor will shut down. All Modes --> Off: The monitor is turned off during doze, standby or suspend mode. Always On Suspend Off Susp, Stby --> Off All Modes This item determines the manner in which the monitor is blanked. V/H SYNC+Blank: This selection will cause the system to turn off the vertical and horizontal synchronization ports and write blanks to the video buffer. Blank Screen: This option only write blanks to the video buffer. DPMS Supported: Initial display power management signaling. V/H SYNC+Blank Blank Screen DPMS Supported This setting names the interrupt request (IRQ) line assigned to the modem (if any) on your system. Activity of selected IRQ always awakens the system. 3, 4, 5, 7, 9, 10, 11, AUTO. If HDD activity is not detected for the length of time specified in this field, the hard disk drive will be powered down while all other devices remain active. Disabled 1~15 Mins This feature allows users to configure the power button function. Instant Off: The power button functions as a normal poweron/-off button. Delay 4 Sec: When you press the power button, the computer enters the suspend/ sleep mode, but if the button is pressed for more than four seconds, the computer will be turned off. This item specifies when your system reboot after a power failure or interrupt occurs. Power Off Power On Last State When enabled, any fax/modem activity wakes up Disabled the system from suspend mode. Enabled Use PCI Wake-up system. PCI must meet PCI Disabled 2.2 specification. Enabled Use this option to set the date and time for your computer to boot up. Date (of month) Alarm* - Indicate the month for system to boot up. Set it to 0 if you want to boot up everyday. Time (hh:mm:ss) Alarm* - Indicate the hour, minute and second for system to boot up. Disabled Enabled *Set Resume by Alarm to Enable, then press "Enter" to show the range of Date and Time Alarm. 34 Chapter 2