Acer TravelMate 2200 Acer TravelMate 2200, TravelMate 2700 and Aspire 1670 Ser - Page 76

Index of Error Messages Error Message List Error Messages Struck Key System CMOS checksum bad - Default configuration used Real time clock error Previous boot incomplete - Default configuration used Invalid System Configuration Data Operating system not found FRU/Action in Sequence See "Keyboard or Auxiliary Input Device Check" on page 65 RTC battery Run BIOS Setup Utility to reconfigure system, then reboot system. RTC battery Run BIOS Setup Utility to reconfigure system time, then reboot system. Main board "Load Setup Defaults" in BIOS Setup Utility. RTC batter Main board. "Load Setup Defaults" in BIOS Setup Utility. Main board. Enter Setup and see if fixed disk and drive A are properly identified. Diskette drive Hard disk drive Main board. Error Message List No beep Error Messages FRU/Action in Sequence Power-on indicator turns off and LCD is blank. Power source (battery pack and power adapter.) See "Power System Check" on page 66. Ensure every connector is connected tightly and correctly. Reconnect the DIMM. Main board. Power-on indicator turns on and LCD is blank. Power source (battery pack and power adapter.) See "Power System Check" on page 66. Reconnect the LCD connector Hard disk drive LCD cable LCD inverter LCD Main board Power-on indicator turns on and LCD is blank. But you can see POST on an external CRT. Reconnect the LCD connectors. LCD cable LCD inverter LCD Main board Power-on indicator turns on and a blinking cursor Ensure every connector is connected tightly and correctly. shown on LCD during POST. Main board Chapter 4 70