Acer Veriton 3000 Veriton 3000 Service Guide - Page 100

BIOS Message CPU Clock Mismatch DMI Table Was Destroyed Equipment Configuration Error Floppy Disk Controller Error Floppy Drive A Error Floppy Drive B Error Floppy Drive(s) Write Protected Hard Disk Drive(s) Write Protected I/O Parity Error IDE Drive 0 Error IDE Drive 1 Error IDE Drive 2 Error IDE Drive 3 Error Insert system diskette and press key to reboot IRQ Setting Error Expansion ROM Allocation Fail I/O Resource Conflict(s) Memory Resource Conflict(s) On Board Parallel Port Conflict(s) On Board Serial Port 1 Conflict(s) On Board Serial Port 2 Conflict(s) Onboard xxx... Conflict(s) PCI Device Error Press Ctrl + Alt + Esc key to enter Setup or F1 key to continue Press Esc to turn off NMI, or any key to reboot PS/2 Keyboard Error or Keyboard Not Connected PS/2 Keyboard Interface Error PS/2 Keyboard Locked PS/2 Pointing Device Interface Error PS/2 Pointing Device Error 68 Action/FRU 1. Enter BIOS Setup and load the default settings. 2. Ensure that the BIOS setting for the processor is set correctly. 1. Flash the BIOS. 1. Ensure that the system configuration set in BIOS Setup is correct. 2. Enter BIOS Setup and load the default settings. 3. RTC battery. 4. Main board. 1. Diskette drive cable/connection. 2. Diskette drive. 3. Main board 1. Ensure that the diskette drive is not set to [Write protect] in the Security Options in BIOS Setup. 2. Load default settings in Setup. 1. Main board. 1. Enter BIOS Setup and load the default settings. 2. Check the IDE drive jumper. 3. IDE hard disk drive power. 4. IDE hard disk drive cable/connection. 5. IDE hard disk drive. 1. Insert a bootable disk into the floppy disk drive or remove this disk if a hard disk is installed. 1. Load default settings in Setup. 2. Enter BIOS Setup and set the Reset Resource Assignments of the PnP/PCI Options to Yes; then reboot the system. 3. Remove all adapter cards that are NOT factoryinstalled and then reboot the system. 1. Enter BIOS Setup and load the default settings. 2. Remove all adapter cards that are NOT factory- installed and then reboot the system. 1. Enter BIOS Setup and load the default settings. 2. Remove all adapter cards that are NOT factory- installed and then reboot the system. 1. Load default settings in Setup. 2. Enter BIOS Setup and set the Reset Resource Assignments of the PnP/PCI Options to Yes, then reboot the system. 3. Remove all adapter cards that are NOT factoryinstalled and then reboot the system. 1. Press Ctrl+Alt+Esc to enter Setup and reconfigure the system. 1. Press Esc to reject the NMI error or press any other key to reboot the system. 1. Reconnect the PS/2 keyboard and mouse. 2. Enter BIOS Setup and load the default settings. 3. PS/2 keyboard. 4. PS/2 mouse. 5. Main board. 1. Reconnect the PS/2 keyboard and mouse. 2. Enter BIOS Setup and load the default settings. 3. PS/2 mouse. 4. PS/2 keyboard. 5. Main board. Chapter 4