Adaptec AHA-2920 Installation Guide - Page 6
Step 10, Step 11, Step 12
View all Adaptec AHA-2920 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Step 10: Prepare each external SCSI device for installation. If you are not installing external SCSI devices, skip to Step 13. s Make sure all SCSI devices (external and internal) are assigned a unique SCSI ID from 0 to 6. Refer to the device's documentation for instructions on setting the SCSI ID. If you plan to boot your computer from a SCSI hard disk drive, assign SCSI ID 6 to this drive. s Install (or enable) terminators on the external device you are attaching at the end of the SCSI chain. Remove (or disable) terminators on all devices that lie between the end of the SCSI chain and the host adapter. On most external SCSI devices, termination is controlled by installing or removing a terminating plug (see Step 11). Refer to the device's documentation to determine how to enable or disable termination on your particular device. Step 11: Plug one end of the external SCSI cable into the host adapter's external SCSI connector and plug the other end of the cable into either one of the SCSI connectors on the external SCSI device. (If you are installing only one external device, attach a terminating plug to the device) 3 Termination Enabled Termination Disabled Termination Disabled Terminating Plug Step 12: Connect other external SCSI devices by daisy-chaining each device to the previous device until all external SCSI devices have been connected. (The device at the end of the chain must have a terminating plug installed.) 2 3 4 Terminating Plug 5