Adaptec AHA-3940U Getting Started Guide - Page 3

3 Default Setting AHA-3940U/3940UW/3940UWD host adapters operate correctly with their factory default settings in most computers with PCI slots. The following table lists the settings and their default values. You can change these settings with the SCSISelect utility. (See Configuring the Host Adapter on page 8.) Global Settings for Host Adapter Default Setting Host Adapter SCSI ID 7 SCSI Parity Checking Enabled Host Adapter SCSI Termination Automatic Boot Device Settings Default Setting Boot Channel A First Boot Target ID 0 Boot LUN Number1 0 SCSI Device Settings Default Setting Initiate Sync Negotiation Maximum Sync Transfer Rate Yes (Enabled) 20 MBytes/sec2 Enable Disconnection Initiate Wide Negotiation3 Send Start Unit SCSI Command4 Yes (Enabled) Yes (Enabled) No (Disabled) Advanced Host Adapter Settings Default Setting Plug and Play SCAM Support Disabled Channel BIOS Support Removable Disks under BIOS as Fixed Disks4 Extended BIOS Translation for DOS Drives > 1 GByte4 Display Message During BIOS Initialization4 Multiple LUN Support4 BIOS Support for Bootable CD-ROM4 BIOS Support for Int 13h Extensions4 Support for UltraSCSI Speed5 Enabled Boot Only Enabled Enabled Disabled Enabled Enabled Disabled 1 Setting is valid only if Multiple LUN Support is enabled. 2 10 MBytes/sec for AHA-3940U. 3 AHA-3940UW/3940UWD only. 4 Settings are only valid if channel BIOS is enabled. 5 If this setting is changed to Enabled, the Maximum Sync Transfer Rates are 20 MBytes/sec for the AHA-3940U and 40 MBytes/sec for the AHA-3940UW/ 3940UWD. 3 AAAAAAAAAAAAAAAAAAPPCAAAAAAaruHiAAArrntAAAArtAAAeN-SAAAn3uAAApt9mAAAeD4AAAcbAAA0aeAAANtUerAAAu::/AAA3mAAA519AAA11b4AAA1/eAAA010rAAAU4:4AAA/04WAAA9-AAA960AAA/43AAA059AAA,6AAA4R8AAA0e-AAAU0vAAA0AAA.WAAABAAADEAAAAAACIAAAnNAAAsAAAtDAAAaAAAlalAAAtaAAAetAAA:i1oAAAAAA1nAAA/G1AAAAAA8uAAA/i9AAAdAAA6eAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA