Alpine D900 Owners Manual - Page 70

Installation Installing the Monitor Installation Location Before deciding on the mounting location, check that opening and closing the display will not hamper gear shifting in that position. Reinforce the monitor unit with a metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (}) already attached to the vehicle's chassis. • For the screw marked }}, use an appropriate screw for the chosen mounting location. Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the IVA-D900. Connect all other leads of the IVA-D900 according to details described in the Connections section. 3 • Install at an angle of within 30 degrees from the horizontal. 1 Mounting Sleeve (Included) Dashboard Mounting Bracket (Included) IVA-D900 Screws (M4 x 3) (Included) Slide the mounting sleeve into the dashboard. Install the supplied bracket on the monitor. 2 Hex Nut (M5) Screw Bolt Stud Metal Mounting Strap Ground Lead Chassis IVA-D900 Front Frame (Included) Lock Pin Slide the IVA-D900 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the supplied Front Frame. Removal 1. Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see Step 3). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin. 2. Pull the unit out, keeping it unlocked as you do so. < JAPANESE CAR > To install using the vehicle's genuine bracket. Ground Lead IVA-D900 Screws (M4 x 3) (Included) Mounting Bracket 68-EN