Alpine HCE-RCAM-WRA Quick Guide - Page 1
Alpine HCE-RCAM-WRA Manual
View all Alpine HCE-RCAM-WRA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Jeep Wrangler HCE-RCAM-WRA Stealth-Mount Spare Tire Camera Quick Installation Manual Model: Wrangler Model Year: 2007-2018 Jeep Jeep Wrangler HCE-RCAM-WRA 1/2 Model Year Wrangler (JK) 2007-2018 Wrangler Unlimited (JK) 2007-2018 * The specified vehicles have been tested and have met compatibility specs at the time of testing. Compatibility is not guaranteed if the manufacturer has made production changes to the listed vehicles above. Warning: Before you begin wiring, remove the ground wire from the negative terminal of the battery. Failing to do so can lead to electric shock, injury or damage to equipment. Installation Kit Parts Camera Bracket W/HCE-C1100 x 1 Power & Video Unit x 1 Retaining Clips x 3 Spare Tire Bracket x 1 Water Proofing Adhesive Pad x 1 Heat Shrink Tube x 1 Camera Extension Cable x 1 Water Proofing Pad x 1 Torx Screw & Lock Washer M6x8 x 1 Quick Installation Manual x 1 Allen Wrench x 1 Torx Screw, Lock Washer, & Nut Extra Nut For M6x12 Screw x 1 Cable Ties x 5 M6x12 x 1 Factory Unit Disassembly (2007-2010 Only) 1) Remove top by releasing 2 rear clips on the back of the top panel and then pull panel forward. 2) Release 2 clips on the top of the bottom panel. This will expose two 7mm screws. Remove those. 3) Release 2 clips on the top of the bottom panel. This will expose two 7mm screws. Remove using a 7mm socket with ratchet & extension. 4) Use panel removal tool to remove dash panel by releasing 6 clips (3 per side). 5) Extract (4) 7 mm screws and remove the factory radio. Factory Unit Disassembly (2010-2018 Only) 1) Remove the rubber cover from the top center storage area and extract (1) 7mm screw. 2) Remove the knee cover panel and extract (2) 7mm screws located to the right and left sides of the steering wheel column. 3) Remove the window switch pod using a panel removing tool and extract (1) 7mm screw. 4) Remove the dash panel. 5) Extract (4) 7 mm screws and remove the factory radio. 6) Extract (2) 7 mm screws from the factory radio bracket and remove it. Glove Box Removal 1) Open the glove box. 2) Push inwards both left and right sides to release the glove box out.