Amana AGG222VD Installation Instruction - Page 16

To Convert Oven Burner 1. Open the oven door and remove oven racks, oven tray, and flame spreader and set aside. 2. Lift oven burner. The orifice spud is behind the oven burner air shutter. A B A. Oven burner B. Air shutter 3. Locate Natural gas orifice spud stamped "51" in the package containing literature supplied with the range. 4. Use a ³⁄₈" combination wrench and remove the LP gas orifice spud. 5. Install the number "51" LP gas spud. 6. Place LP gas oven burner spud in plastic parts bag along with LP gas cooktop burner spuds for future use and keep with the bag containing literature. 7. Reinstall oven burner. 8. Reinstall oven racks, oven tray and flame spreader. Complete Conversion 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Turn the manual shutoff valve in the gas supply line to the "open" position. 3. Refer to "Check Operation of Cooktop Burners" in the "Electronic Ignition System" section for proper burner ignition, operation and burner flame adjustments. IMPORTANT: You may have to adjust the "Lo" setting for each cooktop burner. Checking for proper cooktop and oven burner flames is very important. The small inner cone should have a very distinct blue flame ¼" to ½" (0.6 cm to 1.3 cm) long. The outer cone is not as distinct as the inner cone. Natural gas flames do not have yellow tips. 4. Close the oven door and turn the knob to the "OFF" position. 5. Refer to the "Complete Installation" section to complete this procedure. A A. Natural gas oven orifice spud stamped with "51" IMPORTANT: Do not overtighten. W10459123B © 2012 Whirlpool Corporation. All rights reserved. 8/12 Printed in Mexico