Amana NTW4501XQ Use and Care - Page 9
Washer Maintenance
View all Amana NTW4501XQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
WASHER MAINTENANCE WATER INLET HOSES Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker. CLEANING YOUR WASHER Keep your washer as clean and fresh as your clothes. To keep washer interior odor-free, follow this recommended monthly cleaning procedure: 1. Make sure the washer is empty. 2. Using recommended AFFRESH® washer cleaner, add one tablet to washer basket OR If using liquid chlorine bleach, add 1 cup (250 mL) to liquid chlorine bleach dispenser. NON-USE AND VACATION CARE Operate your washer only when you are home. If moving, or not using your washer for a period of time, follow these steps: 1. Unplug or disconnect power to washer. 2. Turn off water supply to washer, to avoid flooding due to water pressure surge. WINTER STORAGE CARE IMPORTANT: To avoid damage, install and store washer where it will not freeze. Because some water may stay in hoses, freezing can damage washer. If storing or moving during freezing weather, winterize your washer. To winterize washer: 1. Shut off both water faucets; disconnect and drain water inlet hoses. 2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run washer on RINSE & SPIN cycle for about 30 seconds to mix antifreeze and remaining water. 3. Unplug washer or disconnect power. IMPORTANT: Do not add detergent. Do not use more than recommended amount of bleach to avoid damaging product over time. 3. Close washer lid. 4. Select NORMAL HEAVY cycle, HOT Temperature, and LARGE Load Size. 5. Press START/PAUSE/UNLOCK. NOTE: For best results, do not interrupt cycle. If cycle must be interrupted, press START/PAUSE/UNLOCK twice and run a RINSE & SPIN cycle to ensure bleach has been rinsed from washer. Press and hold the START/PAUSE/UNLOCK for 3 seconds to cancel the cycle. Cleaning the liquid fabric softener dispenser 1. Remove dispenser by grasping top with both hands and squeezing, while pushing upward with thumbs. 2. Rinse dispenser under warm water, then replace it. NOTE: To avoid damage to the washer or clothing, do not wash clothes with the liquid fabric softener dispenser removed. Cleaning the bleach dispenser Wipe the inside of the bleach dispenser with a clean, damp cloth. To clean exterior: 1. Use a soft, damp cloth or sponge to wipe up any spills. 2. Use all-purpose surface cleaner, if needed. IMPORTANT: To avoid damaging the washer's finish, do not use abrasive products. TRANSPORTING YOUR WASHER 1. Shut off both water faucets. Disconnect and drain water inlet hoses. 2. If washer will be moved during freezing weather, follow "Winter Storage Care" directions before moving. 3. Disconnect drain from drain system and drain any remaining water into a pan or bucket. Disconnect drain hose from back of washer. 4. Unplug power cord. 5. Place inlet hoses and drain hose inside washer basket. 6. Drape power cord over edge and into washer basket. 7. Place packing tray from original shipping materials back inside washer. If you do not have packing tray, place heavy blankets or towels into basket opening. Close lid and place tape over lid and down front of washer. Keep lid taped until washer is placed in new location. 9