Amana NTW4750Y Use and Care - Page 9

7. Select wash temperature 8. Select cycle options, if desired Once you select a cycle, select the desired wash temperature by turning the Wash Temperature knob to the desired setting. NOTE: Always read and follow fabric care label instructions to avoid damage to your garments. Wash Temp Hot Some cold water is added to save energy. This will be cooler than your hot water heater setting. Warm Some cold water will be added, so this will be cooler than what your previous washer provided. Suggested Fabrics Whites and pastels Durable garments Heavy soils Bright colors Moderate to light soils Cool Lights Warm water is added to assist in soil removal and to help dissolve detergents. Colors that bleed or fade Light soils Cool Darks Warm water may be added to assist in soil removal and to help dissolve detergents. Colors that bleed or fade Light soils Cold This is the temperature from your faucet. If your tap cold water is very cold, warm water may be added to assist in soil removal and help dissolve detergent. Dark colors that bleed or fade Light soils If you would like to add an Extra Rinse, Fabric Softener, Fabric Softener with Extra Rinse and/or use the Stain Treat option, turn the knob for that feature. 9. Press START/Pause/Unlock Lid to begin wash cycle Press the START/Pause/Unlock Lid button to start the wash cycle. Filling is delayed for several minutes while load balance is sensed. When the cycle has finished, the Cycle Complete indicator will light. Promptly remove garments after cycle has completed to avoid odor, reduce wrinkling, and rusting of metal hooks, zippers, and snaps. Unlocking the lid to add garments: If you need to open the lid to add 1 or 2 missed garments: Press START/Pause/Unlock Lid; the lid will unlock once the washer movement has stopped. This may take several minutes if the load was spinning at high speed. Then close lid and press START/Pause/Unlock Lid again to restart the cycle. If lid is left open for more than 10 minutes the water will pump out automatically. Delay in water fill Filling is delayed for 2 to 3 minutes to check for load unbalance. You will hear the hum of the spin prior to filling. This is normal operation. 9