Asko DBI664IXXLS Instructions for installation - Page 3

Placing the dishwasher, Fit the protective film

Page 3 highlights

Placing the dishwasher The dishwasher is intended to be built in under a countertop. The built-in measurements are shown in the illustration. Make sure that the cord and hose hole's edges are even and will not damage the drain and inlet hoses or the power cord. 34 3/8* - 36 1/2 The electrical and water supplies should enter through the area indicated by the shading on the illustration. [''] DBI675 XXLS D) 24 3/4 2244D) 2 *33 7/8'': Remove the trim kit. 5 3/8 24 4 NOTE! Framed cabinets require additional finished filler material behind the face frame for a proper installation. A minimum 3½" (89 mm) finished return is required on all sides of the opening. Fit the protective film Fit the protective film (packed in the document bag) to the underside of the countertop. The protective film is to protect the countertop from moisture. NOTE! The surface to which the protective film is fitted must be clean and dry. 3½" ¾" Frameless cabinetry 3½" Filler Framed cabinetry 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

Placing the dishwasher
The dishwasher is intended to be built in under a countertop. The
built-in measurements are shown in the illustration. Make sure that the
cord and hose hole's edges are even and will not damage the drain
and inlet hoses or the power cord.
24
5 3/8
2
4
24
34
3/8* - 36 1/2
DBI675 XXLS
D)
24 3/4
24
D)
['']
The electrical and
water supplies should
enter through the area
indicated by the
shading on the
illustration.
*33 7/8'': Remove the trim kit.
NOTE!
Framed cabinets require additional finished filler material behind the
face frame for a proper installation. A minimum 3½
(89 mm) finished
return is required on all sides of the opening.
3½”
¾”
3½”
Frameless
cabinetry
Filler
Framed
cabinetry
Fit the protective film
Fit the protective film (packed in the document bag) to the underside
of the countertop. The protective film is to protect the countertop from
moisture.
NOTE!
The surface to which the protective film is fitted must be clean and
dry.
3