Asko DFI664XXL Use and Care Guide - Page 16
Troubleshooting
View all Asko DFI664XXL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Troubleshooting Type of fault on the display F10 Overfilling water 1 F11 Water outlet fault F12 Water inlet fault F40 Inlet valve leakage F52 Water level fault F54 Overfilling water 2 F56 Circ. pump fault Press any button to clear the error message. Problem The buttons do not react when pressed. Cannot close door. The dishwasher does not start. Action Clear the drain pump. See the section Care and maintenance instructions. If the problem persists, call the Customer Care Center. See "Water remains in the dishwasher above the filters" in the table "Problem" below. If the problem persists, call the Customer Care Center. Check that the water supply valve is on. If the problem persists, call the Customer Care Center. The water pressure should be 4.2-140 psi. Turn off the water supply valve and call the Customer Care Center. Call the Customer Care Center. Turn off the water supply valve and call the Customer Care Center. Call the Customer Care Center. Possible causes Action You have pressed the buttons too soon after opening the door. Wait a moment then try again. Child lock (button lock) activated. See the chapter Settings. The door is closed. Open the door. The buttons only react to use when the door is open. The buttons are dirty. Clean with a dry or slightly damp cloth. The baskets are not correctly positioned. Check that the baskets are correctly positioned horizontally. Check that the dishes are not blocking the baskets from sliding properly into place. The Start/Stop start button has been pressed for Press and hold Start/Stop until the display shows too short a time. "Program started, close door in 4 sec". The door is not closed properly or was not closed Close the door within four seconds, otherwise immediately after pressing the Start/Stop button. the dishwasher will not start. A fuse/circuit breaker has been tripped. Check. The plug is not plugged into the power outlet. Check. The water supply valve is turned off. Check. Overflow/leaks. Check. A whirring sound (the drain pump) is heard from Turn off the water supply valve. Pull out the plug the dishwasher and does not stop when the main and call the Customer Care Center. power switch is turned off. Check that the Delayed Start option has not been Press and hold Start/Stop for three seconds if selected. you want to cancel the Delayed Start option. 16