Asko T701 User manual Use & Care Guide EN - Page 20

Timed Dry and Air Fluff When you select Timed Dry or Air Fluff on the program menu, the word "Time" and a number (of minutes) will flash in the upper right corner of the LCD window. This indicates you must select a program time (5 to 90 minutes in 5-minute increments). 1. Press MENU until "Select time" displays. The Delayed Start Program This program lets you delay starting the dryer for up to 24 hours. This feature is useful in areas where utility companies offer discount rates during off-peak hours. When you select Delayed Start on the program menu, you must select a delay time (1 to 24 hours). 1. Press MENU until "Select time for delayed start" displays. 2. To change the number, simply press an Arrow button until the length of time you want the program to run displays. 3. If you only want to use this setting temporarily (for this one load), press START. When the program ends it will revert back to the previous setting. 4. If you want to save this setting permanently, press ENTER again then press START. The program will retain the change. When you press START, the time remaining for the program to run displays in the bottom right-hand corner of the LCD window, as illustrated below: 2. In the bottom right corner of the LCD window, a clockface and a zero will flash. To change the zero, simply press an Arrow button until the LCD displays the number of hours you want to delay starting the program (1-24 hours). 3. If you only want to use this setting temporarily (for this one load), press START. When the program ends it will revert back to the previous setting. 4. If you want to save this setting permanently, press ENTER again then press START. The program will retain the change. When you press START, the clockface and the hours you set for the delay will display, as illustrated below: The remaining time toggles between the minutes remaining (e.g., 23) and the hour(s) remaining (e.g., 1h). The Temperature Menu This menu lets you select a Normal or Low temperature. Only the temperatures available for the dry program you selected will display. 1. Press MENU until "Select temperature" displays. 2. Use the Arrow buttons to toggle between the Normal and Low temperature settings. 3. If you only want to use this setting temporarily (for this one load), press START. When the program ends it will revert back to the previous setting. 4. If you want to save this setting permanently, press ENTER again then press START. The program will retain the change. Selecting Options This lets you select Buzzer, Anti-crease, and Normal or Quick Cooling. Only the options available with the program you selected will display. (See tables on page 14.) 1. Press MENU until "Select Options" displays. 2. Continue to press MENU to scroll through the options. 3. Press an Arrow button to toggle between Off and On 4. If you only want to use this setting temporarily (for this one load), press START. When the program ends it will revert back to the previous setting. 5. If you want to save this setting permanently, press ENTER again then press START. The program will retain the change. RESTORING A PRESET PROGRAM To restore a preset program to its factory default settings, simply press the button (P1-P4) for the preset program you want to restore and hold it down while your press ENTER. The program will revert to its factory default settings. Page 20