Asko W4114CW Installation Instructions English - Page 4

Installing The Drain Hose

Page 4 highlights

See the "Settings" chapter for information on how to switch between "Hot water On" and "Hot water Off". INSTALLING THE DRAIN HOSE Drain hose can also be connected directly to the washbasin drain via a siphon. In this case, the hose, too, should be 24" to 36" (610 mm to 914 mm) above the floor. Internal hose diameter should be at least 0.71" (18 mm). See figure. At least 0.71" (18 mm) If the hose is extended, the internal diameter of the coupling must not be less than ½" (12.2 mm). The machine is supplied with the outlet hose already attached. The hose should be extended over a suitable sink edge or drain pipe at a height of 24" to 36" (610 mm to 914 mm) above the bottom of the unit. (The lower height is preferable.) Make sure the hose is not kinked. Do not extend the drain hose higher than 36" (914 mm) from the bottom of the unit. A C B 24" to 36" 24" to 36" 24" to 36" 4 Customer Care Center, 1-800-898-1879, www.askona.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

4
Customer Care Center, 1-800-898-1879, www.askona.com
See the "Settings" chapter for information on how to
switch between "Hot water On" and "Hot water O
".
INSTALLING THE DRAIN HOSE
The machine is supplied with the outlet hose already
attached. The hose should be extended over a
suitable sink edge or drain pipe at a height of 24"
to 36" (610 mm to 914 mm) above the bottom of the
unit. (The lower height is preferable.) Make sure the
hose is not kinked.
24" to 36"
24" to 36"
24" to 36"
B
C
A
Drain hose can also be connected directly to the
washbasin drain via a siphon. In this case, the hose,
too, should be 24" to 36" (610 mm to 914 mm) above
the
oor. Internal hose diameter should be at least
0.71" (18 mm).
See
gure.
At least 0.71" (18 mm)
If the hose is extended, the internal diameter of
the coupling must not be less than ½" (12.2 mm).
Do not extend the drain hose higher than 36"
(914 mm) from the bottom of the unit.