Asus CUPLE-VM CUPLE-VM User Manual - Page 17
ASUS CUPLE-VM User's Manual, USB Device Wake-up, USBPWR1 / USBPWR2, NOTES, Audio CODEC Setting 12
View all Asus CUPLE-VM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3. HARDWARE SETUP 1) USB Device Wake-up (USBPWR1 / USBPWR2) Set these jumpers to +5V to allow wake up from the S1 sleep state (CPU stopped; RAM refreshed; system running in low power mode) using the connected USB devices. Set to +5VSB to allow wake up from S3 sleep state (no power to CPU; RAM in slow refresh; power supply in reduced power mode). The default setting for the three jumpers is 1-2 to select +5V (because not all computers have the appropriate power supply). NOTES: 1. This feature requires an ATX power supply that can supply at least 2A on the +5VSB lead when these jumpers are set to +5VSB. Otherwise, the system does not power up. 2. The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal working conditions or in sleep mode. USBPWR1 2 1 Disable (Default) 3 2 Enable USBPWR2 CUPLE-VM CUPLE-VM USB Device Wake Up 12 Disable (Default) 23 Enable 2) Audio CODEC Setting (12 pin AC97_EN) Four jumpers control the onboard Audio CODEC setting. If the optional Creative audio chip is on board, these jumpers are not functional. However, without the Creative audio chip, the jumpers may be reset to disable the standard onboard audio CODEC. If disabled, an independent PCI sound card may be installed onboard. The default setting, [1-2], enables the CODEC function. To disable the CODEC, cover all jumpers, [2-3]. SPK ADN# AUD_EN1 AUD_EN2 SPK ADN# AUD_EN1 AUD_EN2 CUPLE-VM 3 2 1 Enable (Default) CUPLE-VM Audio Codec Setting 3 2 1 Disable ASUS CUPLE-VM User's Manual 17