Asus CUR-DLSR CUR-DLSR User Manual - Page 33
SCSI Connection Notes
View all Asus CUR-DLSR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
3. HARDWARE SETUP SCSI Connection Notes This motherboard has two 68-Pin Ultra160 SCSI connectors; one for each of the two channels. The onboard SCSI chipset incorporates an advanced multimode I/O cell that supports both single-ended (SE), Ultra2, and Ultra160 devices. With Ultra160 devices, the SCSI bus platform performs at full Ultra160 speeds (up to 160MB/sec) and extended cabling 12m (or 25m in a point-to-point configuration). When an SE device is attached, the bus defaults to an SE speed and 1.5m cable length. IMPORTANT: Connect SCSI devices as shown. Each channel should have only one type of SCSI standard (e.g. Ultra160, Ultra2, Ultra-Wide). Mixing SCSI devices on the same channel decreases performance of the slower device. 68-pin Internal SCSI Cable (Twisted-Pair Ribbon) Channel A Internal SCSI Devices (up to 15 devices) 68-pin Female Terminator 68-pin Internal SCSI Cable (Twisted-Pair Ribbon) Channel B CUR-DLSR Internal SCSI Devices (up to 15 devices) 68-pin Female Terminator CUR-DLSR SCSI Connection Example NOTE: Ultra160 SCSI devices do not have termination jumpers and must use a separate terminator on the last connector (internal) or device (external). 3. H/W SETUP Connectors ASUS CUR-DLSR User's Manual 33