Asus ESC4000 FDR G2 Cache Vault Accessory Kit Quick Start Guide - Page 5
Installing the Cache Vault Kit on specific
View all Asus ESC4000 FDR G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installing the Cache Vault Kit on specific ASUS server systems After installing the Cache Vault Falsh Module on the PIKE 2208 card, and installing the Cache Vault Power Module on the steel CVPM clip and holder, install these two assemblies to the specific ASUS server systems as instructed below. Installing the kit on RS720-X7/RS8, RS720-E7/RS12, RS720-E7/ RS12-E server systems 1. Locate the two screw holes on the right side of the server chassis. 2. Align the two screws on the side of the steel CVPM holder installed with the Cache Vault Power Module to the two screw holes on the right side of the server chassis. Secure the holder assembly with two screws, and connect the 42'' cable extender to the Cache Vault Power Module. 3. Connect the other end of the 42'' cable extender to the Cache Vault Flash Module that is installed on the PIKE 2208 card. screw locations 4. Install the PIKE 2208 card into the server system. Arrange the cable extender in the direction of the arrows. Installing the kit on TS700-X7/PS4, TS700-E7/RS8 server systems 1. Remove the chassis cover and lay the system on its side on a flat, stable surface. Use a Phillip driver to remove the screw on the metal slot cover and set the screw aside. Remove the metal slot cover. Remove the metal slot cover close to the bottom of the server chassis. Cache Vault Accessory Kit