Asus M2N-E SLI GREEN M2N-E SLI English Edition User''s Manual - Page 44
Internal connectors, IDE connector 40-1 pin PRI_IDE, SEC_IDE
View all Asus M2N-E SLI GREEN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
2.7.2 Internal connectors 1. Floppy disk drive connector (34-1 pin FLOPPY) This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive. The Pin 5 on the connector is removed to prevent incorrect cable connection when using an FDD cable with a covered Pin 5. M2N-E SLI R FLOPPY PIN 1 NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. M2N-E SLI Floppy Disk Drive Connector 2. IDE connector (40-1 pin PRI_IDE, SEC_IDE) The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Drive jumper setting Single device Two devices Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices. If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting. 2-24 Chapter 2: Hardware information