Asus M2N-E SLI GREEN M2N-E SLI English Edition User''s Manual - Page 45
pin SATA1, SATA2, Serial ATA connectors
View all Asus M2N-E SLI GREEN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
SEC_IDE PIN1 PRI_IDE PIN1 M2N-E SLI R NOTE: Orient the red markings (usually zigzag) on the ID ribbon cable to PIN 1. M2N-E SLI IDE Connectors 3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4) These connectors are for the Serial ATA signal cables for Serial ATA 3.0 Gb/s hard disk and optical disk drives. The Serial ATA 3.0 Gb/s is backward compatible with Serial ATA 1.5 Gb/s specification. If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 0+1, RAID 5, or JBOD configuration through the onboard NVIDIA® MediaShield™ controller. The RAID function of these connectors is set to [Disabled] by default. If you intend to create a Serial ATA RAID set using these connectors, enable the RAID Enabled item in the SATA Configuration sub-menu in the BIOS. See section "4.4.7 Onboard Device Configuration" for details. GND RSATA_RXN3 RSATA_RXP3 GND RSATA_TXN3 RSATA_TXP3 GND GND RSATA_RXN1 RSATA_RXP1 GND RSATA_TXN1 RSATA_TXP1 GND M2N-E SLI R SATA1 SATA3 GND RSATA_RXN2 RSATA_RXP2 GND RSATA_TXN2 RSATA_TXP2 GND SATA2 M2N-E SLI SATA Connectors Connect the right-angle side of the SATA signal cable to the SATA device or you may connect the right-angle side of the SATA cable to the onboard SATA port to avoid placement conflict with huge graphics cards. ASUS M2N-E SLI SATA4 right angle side GND RSATA_RXN4 RSATA_RXP4 GND RSATA_TXN4 RSATA_TXP4 GND 2-25