Asus M2N-Plus SLI Vista Motherboard Installation Guide - Page 90

Onboard 1394 [Enabled] Enable or Disable Onboard 1394. Configuration options: [Enabled] [Disabled] Serial Port1 Address [3F8/IRQ4] Allows you to select the Serial Port1 base address. Configuration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3] [Auto] Parallel Port Address [378/IRQ7] Allows you to select the Parallel Port base addresses. Configuration options: [Disabled] [378/IRQ7] [278/IRQ5] [3BC/IRQ7] Parallel Port Mode [EPP] Allows you to select the Parallel Port mode. Configuration options: [Normal] [EPP] [ECP] [Bi-Directional] The ECP Mode Use DMA item becomes user-configurable when the Parallel Port Mode item is set to [ECP] or [Bi-Directional] ECP Mode Use DMA [3] Allows selection of ECP Mode. Configuration options: [1] [3] 4.4.5 SLI Configuration Advanced Phoenix-AwardBIOS CMOS Setup Utility AI-Selector SLI Configuration [Auto] Select Menu Item Specific Help Allow you to select the Scalable Link Interface mode. When set to Auto, BIOS detects the setting of SLI EZ Selector Card. Set to Normal when using single PCI-E graphics card plugged. F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit AI-Selector[Auto] Allows you to select the Scalable Link Interface mode. When set to [Auto], BIOS detects the setting of SLI EZ Selector Card. Set this item to [Single Video Card] when using single PCI-E graphics card. Configuration: [Auto] [Single Video Card] [Dual Video Card] 4-28 Chapter 4: BIOS setup