Asus M2N-SLI Deluxe Wireless Edition M2N-SLI Deluxe English Edition User's Man - Page 50
JMicron JMB363, Serial ATA RAID connector 7-pin SATA_RAID1
View all Asus M2N-SLI Deluxe Wireless Edition manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Connect the right-angle side of the SATA signal cable to the SATA device or you may connect the right-angle side of the SATA cable to the onboard SATA port to avoid placement conflict with huge graphics cards. right angle side 4. JMicron JMB363® Serial ATA RAID connector (7-pin SATA_RAID1) This connector is for a Serial ATA signal cable. This connector supports a Serial ATA hard disk drive that you can configure for RAID through the onboard Serial ATA RAID controller. The JMicron JMB363 controller item in the BIOS is set to [IDE] by default, allowing you to enable the hot-plug function for the external device. Set to [AHCI] or [RAID] to use the connectors to build a RAID set. See section "4.4.7 Onboard Device Configuration" for details. M2N-SLI DELUXE R GND RSATA_RXN1 RSATA_RXP1 GND RSATA_TXN1 RSATA_TXP1 GND SATA_RAID1 M2N-SLI DELUXE SATA RAID Connector Before creating a RAID set using Serial ATA hard disks, make sure that you have connected the Serial ATA signal cables and installed Serial ATA hard disk drives; otherwise, you cannot enter the JMicron® JMB363 RAID utility and SATA BIOS setup during POST. 2-26 Chapter 2: Hardware information