Asus M4N78 PRO User Guide - Page 51

TWR [Auto] Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK] TRRD [Auto] Configuration options: [2 CLK] [3 CLK] [4 CLK] [5 CLK] [Auto] DCT0 2nd Information: 7-105-75 TWTR [Auto] Specifies the write to read delay when accessing the same DIMM. Configuration options: [1 CLK] [2 CLK] [3 CLK] [Auto] TRFC0/TRFC1 [Auto] Configuration options: [Auto] [75ns] [105ns] [127.5ns] [195ns] [327.5ns] DCT0/DCT1 Strength Config [Auto] Allows adjustments of the advanced DRAM strength parameters. Configuration options: [Auto] [DCT 0] [DCT 1] [Both] The following sub-items appear only when you set the DCT0/DCT1 Strength Config. item to [DCT 0], [DCT 1] or [Both]. DCT0:CKE drive strength. [Auto] DCT1:CKE drive strength. [Auto] Configuration options: [Auto] [1x] [1.25x] [1.5x] [2x] DCT0:CS/ODT drive strength. [Auto] DCT1:CS/ODT drive strength. [Auto] Configuration options: [Auto] [1x] [1.25x] [1.5x] [2x] DCT0:Address/Command drive strength. [Auto] DCT1:Address/Command drive strength. [Auto] Configuration options: [Auto] [1x] [1.25x] [1.5x] [2x] DCT0:MEMCLK drive strength. [Auto] DCT1:MEMCLK drive strength. [Auto] Configuration options: [Auto] [0.75x] [1x] [1.25x] [1.5x] DCT0:Data drive strength. [Auto] DCT1:Data drive strength. [Auto] Configuration options: [Auto] [0.75x] [1x] [1.25x] [1.5x] DCT0:DQS drive strength. [Auto] DCT1:DQS drive strength. [Auto] Configuration options: [Auto] [0.75x] [1x] [1.25x] [1.5x] DCT0:Processor on-die termination [Auto] DCT1:Processor on-die termination [Auto] Configuration options: [Auto] [300 ohms +/- 20%] [150 ohms +/- 20%] [75 ohms +/- 20%] DQS Timing Configuration This item appears only when you set the AI Overclocking item to [Manual] and allows you to change the advanced DQS settings. DQS Timing User Controls [Auto] Allows adjustments of the advanced DQS parameters. Chapter 2: BIOS setup 2-15