Asus MAXIMUS IV EXTREME-Z User Manual - Page 64
Marvell, Serial ATA 6.0 Gb/s connectors, pin SATA6G_E1/E2 [red], Marvell shared, library - raid
View all Asus MAXIMUS IV EXTREME-Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
3. Marvell® Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [red]) These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s signal cables. • The SATA6G_E1/E2 (red) connectors are for data drives only. • You must install Windows® XP Service Pack 3 or later versions before using Serial ATA hard disk drives. • When using hot-plug and NCQ, set the Marvell Controller item in the BIOS to [AHCI Mode]. Refer to section 3.5.6 Onboard Devices Configuration for details. • Press + during POST to enter the Marvell RAID utility to create or delete a RAID configuration. • If you want to install a Windows operating system to a RAID configuration created using the Marvell SATA controller, you have to create a RAID driver disk using the motherboard support DVD and load the driver during OS installation. For 32/64bit Windows XP OS, load first the Marvell shared library driver, and then load Marvell 91xx SATA Controller Driver. For Windows Vista / Windows 7 OS, load only the Marvell 91xx SATA Controller Driver. 2-32 Chapter 2: Hardware information