Asus P1-P5945G User Guide - Page 51
IDE Connector
View all Asus P1-P5945G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
2 IDE connectors (40-1 pin PRI_IDE) The onboard IDE connectors are for Ultra DMA 100/66/33 signal cable(s). There are three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device(s). PRI_IDE PIN1 R IDE Connector NOTE: Orient the red markings (usually zigzag) on the ID ribbon cable to PIN 1. Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode Cable of device(s) - Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices. If any device jumper is set as "Cable-Select", make sure all other device jumpers have the same setting. 4- Chapter 4: Motherboard info