Asus P4VP-MX P4VP-MX user's manual English version E1538 - Page 28

3. IDE connectors (40-1 pin PRI_IDE, SEC_IDE) This connector supports the provided UltraDMA133/100 IDE ribbon cable. Connect the cable's blue connector to the primary (recommended) or secondary IDE connector, then connect the gray connector to the UltraDMA133/100 slave device (hard disk drive) and the black connector to the UltraDMA133/100 master device. It is recommended that you connect non-UltraDMA133/100 devices to the secondary IDE connector. If you install two hard disks, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings. BIOS supports specific device bootup. If you have more than two UltraDMA133/100 devices, purchase another UltraDMA133/100 cable. You may configure two hard disks to be both master devices with two ribbon cables - one for the primary IDE connector and another for the secondary IDE connector. 1. Pin 20 on each IDE connector is removed to match the covered hole on the UltraDMA cable connector. This prevents incorrect orientation when you connect the cables. 2. The hole near the blue connector on the UltraDMA133/100/66 cable is intentional. 3. For UltraDMA133/100/66 IDE devices, use the 80-conductor IDE cable. SEC_IDE PRI_IDE ® P4VP-MX NOTE: Orient the red markings on the IDE ribbon cable to PIN 1 P4VP-MX IDE Connectors PIN 1 PIN 1 4. Front panel audio connector (10-1 pin AUDIO1) This is an interface for the Intel front panel audio cable that allow convenient connection and control of audio devices. ® P4VP-MX AUDIO1 MIC2 MICPWR Line out_R NC Line out_L AGND +5VA BLINE_OUT_R BLINE_OUT_L P4VP-MX Front Panel Audio Connector 1-18 Chapter 1: Product introduction