Asus P5B PREMIUM VIST Motherboard Installation Guide - Page 51
JMicron JMB363, Serial ATA RAID connector 7-pin SATA_RAID, Digital audio connector 4-1 pin SPDIF_OUT
View all Asus P5B PREMIUM VIST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
P5B R GND RSATA_RXN RSATA_RXP GND RSATA_TXN RSATA_TXP GND 4. JMicron JMB363® Serial ATA RAID connector (7-pin SATA_RAID) This connector is for a Serial ATA signal cable. This connector supports a Serial ATA hard disk drive that you can configure for RAID through the onboard Serial ATA RAID controller. The JMicron controller mode item in the BIOS is set to [AHCI] by default, allowing you to use the connectors to build a RAID set. See section "4.4.5 Onboard Device Configuration" for details. SATA_RAID P5B SATA RAID Connector Before creating a RAID set using Serial ATA hard disks, make sure that you have connected the Serial ATA signal cables and installed Serial ATA hard disk drives; otherwise, you cannot enter the JMicron® JMB363 RAID utility and SATA BIOS setup during POST. 5. Digital audio connector (4-1 pin SPDIF_OUT) This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port(s). Connect the S/PDIF Out module cable to this connector, then install the module to a slot opening at the back of the system chassis. P5B R +5V SPDIFOUT GND P5B Digital Audio Connector SPDIF_OUT The S/PDIF module is purchased separately. ASUS P5B 2-27