Asus P5GPL P5GPL English user's manual - Page 44
By default, the pins labeled Chassis Signal and Ground are shorted
View all Asus P5GPL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Right Audio Channel Ground Ground Left Audio Channel 8 . Optical drive audio connector (4-pin CD) This connector is for the 4-pin audio cable that connects to the audio connector at the back of the optical drive. P5GPL CD P5GPL CD audio connector 9 . Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS P5GPL (Default) P5GPL Chassis intrusion connector +5VSB_MB Chassis Signal GND 1-32 Chapter 1: Product introduction