Asus P5KEPU User Manual - Page 50
Internal connectors, Floppy disk drive connector 34-1 pin FLOPPY, IDE connector 40-1 pin PRI_E IDE
UPC - 610839160570
View all Asus P5KEPU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
2.7.2 Internal connectors 1. Floppy disk drive connector (34-1 pin FLOPPY) This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive. Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5. P5K/EPU FLOPPY ® PIN 1 NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. P5K/EPU Floppy disk drive connector 2. IDE connector (40-1 pin PRI_E IDE) The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. P5K/EPU PRI_EIDE NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. ® P5K/EPU IDE connector Drive jumper setting Single device Two devices Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray 2-26 Chapter 2: Hardware information