Asus P5P41TD User Manual - Page 31
P5P41TD IDE connector
View all Asus P5P41TD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
2. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices. P5P41TD PRI_IDE P5P41TD IDE connector PIN1 NOTE:Orient the red markings on the IDE ribbon cable to PIN 1. If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the same setting. ASUS P5P41TD 1-21