Asus P5S-VM P5S-VM User Manual - Page 30
IrDA-Compliant Infrared Module Connector IR, 5-pin block
View all Asus P5S-VM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
01 01 III. H/W SETUP Connectors III. HARDWARE SETUP 12. ATX Power Supply Connector (ATX, 20-pin block) This connector connects to an ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned. IMPORTANT: Make sure that your ATX power supply can supply at least 10mAmp on the 5-volt standby lead (+5VSB). You may experience difficulty in powering on your system if your power supply cannot support the load. For Wake on LAN support, your ATX power supply must supply at least 720mAmp. +12.0 Volts +5V Standby Power Good Ground +5.0 Volts Ground +5.0 Volts Ground +3.3 Volts +3.3 Volts +5.0 Volts +5.0 Volts -5.0 Volts Ground Ground Ground Power Supply On Ground -12.0 Volts +3.3 Volts P5S-VM ATX Power Connector 13. IrDA-Compliant Infrared Module Connector (IR, 5-pin block) This connector supports the optional wireless transmitting and receiving infrared module. This module mounts to a small opening on system cases that support this feature. You must also configure the setting through UART2 Use Infrared in Chipset Features Setup to select whether UART2 is directed for use with COM2 or IrDA. Use the five pins as shown below (Back View) and connect a ribbon cable from the module to the motherboard according to the pin definitions. Front View Back View IRRXH GND +5V IRRX IRTX P5S-VM Infrared Module Connector IRTX GND IRRX +5V (NC) 30 ASUS P5S-VM User's Manual