Asus SABERTOOTH Z97 MARK 1 Installation Guide - Page 5

Installing the assistant fans The SABERTOOTH Z97 MARK I motherboard package comes with a 35 mm and a 40 mm assistant fans for additional cooling solution and better airflow. To install the 40 mm assistant fan: 1. Locate and remove the screw on the back I/O (A) then remove the back I/O fan cover lid (B). Keep the screw for later use. 2. Get the bundled 40 mm assistant fan and position it to an orientation where its THE ULTIMATE FORCE logo is facing towards the back I/O shield. 3. Match the two screw holes on the 40 mm assistant fan with the two screw holes on the cover lid and secure it with the bundled set of two (2) screws. 4. Align and insert the cover lid and the assistant fan assembly into the Thermal Armor and secure it with the screw that you removed in step 1. Ensure to tuck the fan cable inside the cable corner slot. 5. Connect the fan cable connector to the assistant fan (ASST_FAN3) header on the motherboard. 6. Launch the Thermal Radar 2 utility on your computer to adjust the fan's behaviour. For more information about the Thermal Radar 2 utility, refer to your motherboard's user guide. Fan cable corner slot 5