Audiovox GMRS7015RC Owners Manual - Page 22

Troubleshooting

Page 22 highlights

• Turn your transceiver off on board aircraft when requested to do so. • Do not place your radio in front of a vehicle's air-bag. If the air-bag deploys, it could propel the transceiver like a projectile causing bodily injury. Troubleshooting Problem No transmission while pressing the PTT Button Weak or no signal received Unit beeps, but will not function when turned on Reception of unwanted signals Possible cause Weak batteries Incorrect battery polarity Weak batteries Channel and privacy code not set the same as target transceiver Volume level too low PTT Button inadvertently pressed Excessive radio interference on a particular channel Obstruction of radio signal Batteries extremely discharged CTCSS privacy mode not on Interference from electronic devices such as computers and TVs. Correction Charge or replace batteries Install the batteries following the directions in paragraph Installing the Batteries. Charge or replace batteries Adjust the transceiver's settings to match those settings of the target transceiver Increase volume level Release PTT Button Change to a different channel Avoid operating in or near large buildings or vehicles Charge or replace batteries Turn on the CTCSS privacy mode and set code number to match the setting of the target transceiver. Turn the devices off or move farther away from them. 22 128-7961 22 of 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

128-7961
22 of 28
Turn your transceiver off on board aircraft when requested to do so.
Do not place your radio in front of a vehicle’s air-bag. If the air-bag
deploys, it could propel the transceiver like a projectile causing bodily
injury.
Troubleshooting
22
Weak or no
Weak batteries
Charge or replace batteries
signal received
Channel and privacy
Adjust
the transceiver’s
code not set the same
settings to match those
as target transceiver
settings of the target
transceiver
Volume level too low
Increase volume level
PTT Button inadvertently
Release PTT Button
pressed
Excessive radio interference
Change to a different
on a particular channel
channel
Obstruction of radio signal
Avoid operating in or near
large buildings or vehicles
Unit beeps, but
Batteries extremely
Charge or replace batteries
will not function
discharged
when turned on
Reception of
CTCSS privacy mode
Turn on the CTCSS privacy
unwanted signals
not on
mode and set code number to
match the setting of the
target transceiver.
Interference from
Turn the devices off or move
electronic devices such as
farther away from them.
Problem
Possible cause
Correction
No transmission
Weak batteries
Charge or replace batteries
while pressing
Incorrect battery polarity
Install the batteries
the PTT Button
following the directions in
paragraph Installing the
Batteries.
computers and TVs.