Audiovox SRSIR001FM Installation Manual - Page 11
Installing The Satellite System Control Unit Scu
UPC - 044476009044
View all Audiovox SRSIR001FM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
INSTALLING THE SATELLITE SYSTEM CONTROL UNIT (SCU) PROCEDURE for a TYPICAL INSTALLATION of the SCU USING HOOK & LOOP ADHESIVE TAPE (SUPPLIED) 1. Determine where the SCU is to be located (flat surface) NOTE: The chosen position must allow a clear view of the display and easy access to the controls for both the Driver and Passenger of the vehicle. 2. Using an Alcohol Swab, clean and dry the entire surface area where the SCU is to be mounted and the back surface of the SCU. 3. Remove the protective paper from the back of the first piece of the supplied Hook & Loop Adhesive Tape (Loop side) and apply it to the mounting surface (see Figure 1.) 4. Remove the protective paper from the back of the second piece of the supplied Hook & Loop Adhesive Tape (Hook side) and apply it to the back side of the SCU (see Figure 2.). Position the SCU cable in the appropriate directional channel on the back of the SCU so that the back surface is flat (see Figure 3.). 5. Carefully press the SCU into place. 6. Connect the SCU Cable to the 6 - pin Din Cable from the RRU Velcro Tape (Loop) Hook & Loop Adhesive Tape (Hook) Figure 1. Figure 2. Figure 3. NOTE: Do not install the unit in the following locations: In Locations exposed to direct sunlight. Where hot air is discharged from the car heater. In areas subject to extreme temperatures. 11