Audiovox XMB10 User Guide - Page 14
Troubleshooting
View all Audiovox XMB10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Troubleshooting FAULT System does not turn on XMB10 does not operate using batteries Intermittent operation ANTENNA error message NO SIGNAL message No sound from XMB10 speakers PROBABLE CAUSE Receiver power is set to off Batteries not installed or installed incorrectly As long as the AC power connector is attached to the rear panel, operation is disabled REMEDY Turn Receiver power on using the Xpress Power On/Off button Install batteries observing correct polarity Remove power connector from rear panel of XMB10 Low battery level Satellite antenna not connected to XMB10 rear panel Xpress Receiver not firmly seated in cradle mounting plate Check for obstacles over or around antenna Headphones installed Replace batteries Connect satellite antenna to XMB10 rear panel ANT jack Press firmly down on the Receiver to ensure that the connector is firmly mated to the Boom Box connector Change location to eliminate nearby obstacles (bridges, etc.) Remove headphones -14- 128-7546 14 of 16