Behringer CABLE TESTER CT100 Manual - Page 4

Phantom Power Detect, Wiring - 6 in 1 cable tester

Get Behringer CABLE TESTER CT100 PDF manuals and user guides View all Behringer CABLE TESTER CT100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

CABLE TESTER CT100 TEST TONE MODE may be used to check signal flow and to facilitate level adjustments. It routes a test tone to the “+ pin” (pin 2/tip) of all OUT jacks. Use the TEST TONE LEVEL switch to choose between +4 dBu, -10 dBV, or -50 dBV mic level. Please note that this mode is not intended to work as a voltage standard and that battery voltage will affect the test tone output level. 4.1 Selection between 1 kHz and 440 Hz While in TEST TONE MODE, pressing RESET toggles between 1 kHz and 440 Hz. The TEST TONE LED indicates the selected frequency: On = 1 kHz, Off = 440 Hz. 5. PHANTOM POWER DETECT In TEST TONE MODE, pins 2 and 3 are monitored for external DC voltage (commonly supplied for condenser microphones). The PHANTOM LEDs will light if DC voltage above approx. 9 V is detected. 6. WIRING 1/4", TT, 1/8" TRS connectors (mono or TS connectors also work) 4 MIDI connector (2 pins unused)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
CABLE TESTER CT100
4
TEST TONE MODE may be used to check signal flow and to facilitate
level adjustments. It routes a test tone to the ²+ pin³ (pin 2/tip) of all
OUT jacks. Use the TEST TONE LEVEL switch to choose between
+4 dBu, -10 dBV, or -50 dBV mic level. Please note that this mode is
not intended to work as a voltage standard and that battery voltage
will affect the test tone output level.
4.1
Selection between 1 kHz and 440 Hz
While in TEST TONE MODE, pressing RESET toggles between 1 kHz
and 440 Hz. The TEST TONE LED indicates the selected frequency:
On = 1 kHz, Off = 440 Hz.
5.
PHANTOM POWER DETECT
In TEST TONE MODE, pins 2 and 3 are monitored for external DC
voltage (commonly supplied for condenser microphones). The
PHANTOM LEDs will light if DC voltage above approx. 9 V is detected.
6.
WIRING
1/4", TT, 1/8" TRS connectors
(mono or TS connectors also work)
MIDI connector
(2 pins unused)