Behringer DCX2496LE Manual - Page 11

20 ULTRADRIVE PRO DCX2496/ULTRADRIVE DCX2496LE User Manual 6.3 3x bi-amp operation (LCR/Triple Bi-Amping) XENYX X2222USB Mixing console Left Center Right channel In A In B In C Low High Outputs: 1 2 3 4 5 6 Low High EUROPOWER EP2000 Stereo power amplifier Low High High (2) Left Mid High (4) (Center) High (6) Right Low (1) EUROLIVE B1520 PRO Low (3) Low (5) 21 ULTRADRIVE PRO DCX2496/ULTRADRIVE DCX2496LE User Manual 6.4 Stereo operation plus mono subwoofer XENYX X2222USB Mixing console High (1) Right Stereo output Left In A In B Outputs: 1 2 3 (4, 5 and 6 not used) EUROLIVE B1800X PRO B815NEO Left active loudspeaker B815NEO Right active loudspeaker Passive mono subwoofer SUM (A + B) signal EUROPOWER EP2000 Stereo power amplifier (mono bridged) Low (3) Fig 6.3: 3x2-way operation [LCR/Triple Bi-Amping] Three 2-way speakers driven from three inputs. Such a setup is used for stage monitors or in cinemas, where, in most cases, the two stereo cabinets (completely to the left and right) are used to play back music and effects, while the center cabinet reproduces voices. Hence the name L-C-R, which stands for "Left-Center-Right". Note that this scenario will not work for the DCX2496LE as it does not have an INPUT C jack. Output 4 usable as additional mono delay line output. Output 5 + 6 usable as additional stereo delay line output. Fig. 6.4: Stereo operation plus mono subwoofer A full-range stereo signal is sent to two active speaker cabinets for stereo reproduction. There is no need for a dedicated frequency separation because the crossover and amplifier in the active speaker are perfectly adapted to each other. However, to achieve more power in the bass, low frequencies are cut off in the active cabinets and routed to a subwoofer. The power amp is set to mono-bridged mode and the SUM signal derived from In A+B is sent to the subwoofer. Outputs 4 to 6 can be used as mono or stereo delay lines.