Behringer EURORACK UB1832FX-PRO Manual - Page 10

10 EURORACK UB2442FX-PRO/UB2222FX-PRO/UB1832FX-PRO/UB1622FX-PRO User Manual AUX SEND (FX) The AUX SEND (FX) jack carries the master aux mix (from the channel's FX controls). You can connect this to an external effects device to process the FX bus. The processed signal can then be brought from the effects device back into the STEREO AUX RETURN jacks. 2.3.3 Stereo aux return connectors 2.3.4 The monitor section of the UB1832FX-PRO One of the ways that the UB1832FX-PRO differs from the other models of this series is that it has a separate monitor output. UB1832FX-PRO Fig. 2.10: Monitor output of the UB1832FX-PRO The first aux send (MON) on this console is used to set up the monitor mix from the channels and route it to the MON SEND fader. UB1832FX-PRO Fig. 2.9: The aux return connectors UB2442FX-PRO ◊ On the UB2222FX-PRO, UB1832FX-PRO and UB1622FX-PRO the STEREO AUX RETURN jacks are located on the front panel of the unit. STEREO AUX RETURN The STEREO AUX RETURN 1 jacks generally serve as the return for the effects mix (created using the post-fader aux sends) by connecting the output of an external effects device. If only the left jack is connected, the AUX RETURN is automatically switched to mono. ◊ You can also use these jacks as additional line inputs. All stereo aux returns are balanced, but can of course also be used with unbalanced connectors. If you use an aux send for monitoring, the associated unused stereo aux returns are available for other line level signals (e.g. keyboards). ◊ A signal fed into the stereo return jacks can be output via an aux send jack. More information on this can be found in chapter 2.3.5 "STEREO AUX RETURN 1/2 (TO AUX SEND)". STEREO AUX RETURN FX The STEREO AUX RETURN FX jacks accept the effects mix return (created using the channel FX sends). If these jacks are already in use as additional inputs, you can route the effects signal back into the console via a different channel. The advantage of this is that you can now use that channel's EQ on the effects return signal. ◊ In this instance, the FX control of the channel being used as an effects return should be turned fully counterclockwise, otherwise feedback problems could occur! ◊ If you wish to use the internal effects processor, do not plug any connectors into the STEREO AUX RETURN FX jacks, unless you want to tap the processed signal via the FX OUT (UB2222FX-PRO and UB2442FX-PRO only). UB1832FX-PRO Fig. 2.11: Monitor fader of the UB1832FX-PRO MUTE Press the MUTE switch to mute the monitor send. SOLO The SOLO switch routes the monitor send to the solo bus (post-fader and post-mute) or to the PFL bus (pre-fader and pre-mute). The position of the MODE switch in the main section determines which of the buses is selected. 2.3.5 Stereo aux return control STEREO AUX RETURN 1 The STEREO AUX RETURN 1 control determines the level of this signal in the main mix. If STEREO AUX RETURN 1 is used as effects return, this will determine the level of the effects when mixed with any "dry" channel signal. ◊ When used in this way, the effects device should be set at 100% effect. UB2442FX-PRO Fig. 2.12: Stereo aux return and stereo aux return (to aux send) controls