Behringer FEX800 User Manual - Page 11

DEUTSCH MINIFEX FEX800 + Please make sure that the FEX800 provides only one effect signal in this type of application (MIX BALANCE control turned fully right). MINIFEX FEX800 Fig. 4.1: Wiring the MINIFEX via the aux paths 4.2 The MINIFEX in the insert path If your mixing console is equipped with insert paths, you can also connect the MINIFEX using these combined inputs/outputs. In this case, the effects unit is directly integrated into the signal path of the mixing console. Such a configuration is usually required for signal processors such as compressors, because you only want to use the processed signal rather than a mix of direct and effects signals. In order to use an effects unit such as the MINIFEX in the insert path, you will have to adjust the desired volume ratio of direct vs. effect signal with the MIX BALANCE control . Please use the respective channel insert to process specific instruments. Groups of instruments or stereo mixes can be processed with the sub-group/main-mix inserts. Regler einstellen. Fig. 4.2: Wiring the MINIFEX via the insert paths 4.3 The MINIFEX as an effects unit for instruments You can also use the MINIFEX on stage as an effects unit for keyboards. This can be useful if your keyboard has only limited effect capabilities or if you want to process selected sounds with the MINIFEX effects via existing single outputs. The illustration below shows how to wire the FEX800 either to an amplifier or via a D.I. box to a mixing console. You can switch the effect on and off using an additional footswitch. 4. APPLICATION EXAMPLES 11