BenQ MP620 User Manual - Page 31

If you forget the password You will be asked to enter the four digit password every time you turn on the projector. If you enter the wrong password, the password error message displays. You can retry by pressing Up 5, or if you did not record the password in this manual, and you absolutely do not remember it, you can use the password recall procedure. Password Error Try again Forgot password, please refer to User's manual Entering the password recall procedure Press and hold Right4on the projector for 3 seconds. The projector will display 4 sets of coded number on the screen. Write down the number and turn off your projector. Seek help from the local BenQ service center to decode the number. You may be required to provide proof of purchase documentation to verify that you are an authorized user of the projector. Changing the password 1. Open the on-screen menu and go to 2. Press Left 3or Right4. Setting > Change Password. 3. Enter the old password. i. If the password is correct, you can go on to enter new password. ii. If the password is incorrect, a "Password Error" message displays. Press Up 5 to try again or press Down 6 to cancel. 4. Enter a new password. IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password down here in this manual in advance or right after the password is entered so that it is available to you should you ever forget it. Password Keep this manual in a safe place. 5. Perform one of the following 3 steps. i. Press AUTO to confirm. ii. Press Up 5 to try again. iii. Press Down 6 to cancel the set-up and return to the on-screen menu. 6. Confirm the new password by re-entering the new password. 7. Perform one of the following 3 steps. i. Pressing AUTO completes the procedure. ii. Press Up 5 to try again. iii. Press Down 6 to cancel the set-up and return to the on-screen menu. Operation 27